#How to install sun explorer in solaris 11 commands code
System – This component returns the percentage of CPU time spent running the system kernel code (system time).
It is recommended to use the lowest threshold possible. This statistic depends on the programs that the user is running. This represents the time spent executing user code.
The -r switch enables a kernel compile, which creates a device specific file used for communication with the LTO tape drive. With the LTO drive connected and powered on, reboot the system using the command boot -r. There are five spaces between the words IBM and ULTRIUM-TD1 for the Solaris 7 and 8 st.conf entries.If other devices are listed after this entry and are not commented out, then end this line with a comma. The line immediately after tape-config-list= ends with a semi-colon only if it is the last device in the tape-config-list.Uncomment tape-config-list= before you add the entry for the LTO tape drive. If no devices have ever been added to the st.conf file, all entries are commented out with a # sign.It is highly recommended that you make a copy of your st.conf file before you attempt to modify it.The st.conf file is located in the /kernel/drv directory. The system uses this file when it is powered on or rebooted to determine what devices are connected to the bus and how they are configured. Configuring the Kernelīefore you can use a LTO tape drive with the Solaris operating system, you must modify the st.conf file. Apply power to the LTO drive and bring the system back up. Shut down the Solaris system and attach the LTO tape drive to the SCSI bus. Refer to your LTO or library instructions on setting the drive's SCSI ID. Choose an unused SCSI ID for your LTO drive. This will display all detected SCSI devices and their SCSI IDs. To find the available SCSI ID's you need to halt the system.Ĭaution: Make sure no users are on the system before halting.įrom the command prompt enter probe-scsi-all. Then modify the st.conf file and rebuild the kernel. First select an unused SCSI ID for the tape drive. To install a LTO tape drive on a Sun Solaris system, you need to do two things.